Cat Eye Magnetic Gel Polish

Yes. You should mix the gel polish before applying it because the magnetic particles can settle while the bottle sits between uses. Before each application, shake the bottle gently or roll it between your hands to help redistribute the particles evenly through the formula.

This simple step supports a smoother application and a more consistent cat eye effect when you use the product. Remember to always check the specific directions first, as correct preparation can help you get better control and a more consistent magnetic finish for the set.

The right number of coats depends on the formula, the shade, and the finish you want to create. Some of the colours may give enough coverage in one coat, especially if they are highly pigmented or applied over a base colour.

For a richer result, 2 thin coats are usually preferred because they can build depth, improve coverage, and make the magnetic effect appear stronger. Keep each coat even and cure fully before applying the next layer for a polished look.

Absolutely. This gel polish can be applied over another fully cured gel polish colour. The shade underneath will influence the final look, from the strength of the magnetic line to the overall depth of the finish.

A dark base, such as black, often creates stronger contrast and makes the cat eye effect appear more defined. Lighter, sheer, or nude bases can soften the result for a more subtle glow.

Simply apply the base colour first, cure it properly, then layer the gel polish and activate it with a magnet before curing. If you plan on adding multiple coats of the gel polish, don’t forget to keep activating that layer with the magnet and then curing again afterwards.

Hold the magnet close to the uncured gel polish without touching the nail surface. A distance of around 2–5 mm is usually a good guide, as it gives the magnetic particles enough pull without disturbing the product.

Keeping the magnet closer can create a sharper, more defined line, while holding it slightly higher can give a softer, wider effect. Work one nail at a time and position the magnet until you like the pattern.

Yes. You can change the pattern before curing, as long as the gel polish is still uncured. The magnetic particles stay movable, so you can adjust the magnet’s position to refine the line, adjust the overall curve, or create a softer shimmer effect.

Work slowly and check the nail from different angles until the placement looks balanced. Once you’re happy with the design, cure the gel promptly under the lamp to set the particles in place and help maintain a clean, defined cat eye finish.

A streaky or uneven finish usually comes from a product that has been applied too thinly, too heavily in patches, or without enough consistency across the nail. When some areas have fewer magnetic particles, the effect can look patchy instead of smooth and defined.

Apply a balanced, even coat, and work on one nail section at a time so you can control the magnet placement before curing. Keep your coat thickness, magnet distance, and timing as consistent as possible to create a cleaner, more uniform cat eye result.

Of course! You can apply a matte top coat over the gel polish when you want a softer, more velvety finish instead of a high-gloss shine. This technique can work well for muted designs or those who prefer a less reflective look.

Keep in mind, though, that it will typically soften the magnetic effect. Because matte top coats diffuse light, a glossy top coat is usually the better choice when you want maximum depth, contrast, and shimmer.

This gel polish can usually be removed the same way as other soak-off gel polishes. Start by gently breaking the top-coat seal, then soak the product with acetone until it softens and lifts easily from the nail. Avoid peeling, picking, or forcing the gel off, as this can weaken or damage the natural nail.

If the polish is still holding, give it more soaking time rather than scraping harder. A patient removal process helps protect nail health and keeps the nail plate in better condition for your next set.

Store this product tightly closed in its original bottle between appointments, all to help protect the formula and keep it ready for your next set. Plus, place the bottle upright in a cool, dry place, away from direct sunlight, heat, and any UV or LED lamps, especially since exposure can affect a curable gel product.

Last but not least, wipe the neck of the bottle before closing if needed, and avoid leaving it open during services. Good storage habits help maintain product consistency, application control, and long-lasting salon-quality performance.